| Command: mlt |
Configures MultiLink Trunking (MLT) to set up MLTs on the switch.
mlt <1-64> bpdu {all-ports | single-port}
mlt <1-64> {disable | enable}
mlt <1-64> learning {disable | fast | normal}
mlt <1-64> loadbalance {advance | basic}
mlt <1-64> member <port>
mlt <1-64> name <WORD>
default mlt <1-64> bpdu
no mlt <1-64>
None
Global Configuration
| Parameter | Description |
|---|---|
|
{disable | enable} | Disables or enables the trunk. By default, a new MLT is disabled. |
|
<1-64> | Specifies the MLT ID. |
|
bpdu {all-ports | single-port} | Specifies the BPDU send and receive mode. The default is all-ports. |
|
learning {disable | fast | normal} | Configures STP learning mode. |
|
loadbalance {advance | basic} | Specifies the MLT load balancing mode. Basic provides MAC address-based load balancing. Advance provides IP-based load balancing. The default is basic. |
|
member <port> | Specifies a port or list of ports to assign as members of the MLT. |
|
name <WORD> | Specifies a unique, alphanumeric identifier for the MLT, with a maximum of 16 characters. |