| Command: script run |
Runs an ASCII configuration file from a USB mass storage device, or from a TFTP/SFTP server on a switch or stack. The following parameters force the script to load from the specified source, and then run.
script run <-1-127>
script run tftp <Hostname|A.B.C.D|WORD> <WORD>
script run sftp <Hostname|A.B.C.D|WORD> username <WORD>
script run usb unit <1–8> <WORD>
None
Privileged EXEC
| Parameter | Description |
|---|---|
|
<1–127> | Specifies the index in the ASCII configuration script table of the script to be loaded. |
|
<Hostname|A.B.C.D|WORD> | Specifies an alphanumeric host name, an IPv4 address, or an IPv6 address. |
|
<WORD> | Specifies a filename for the script. |
|
sftp | Specifies the script loads from the SFTP server. |
|
tftp | Specifies the script loads from the TFTP server. You must add the enable and configure terminal commands to the ASCII configuration script table file. If you do not add the enable and configure terminal commands, the ASCII script does not auto download from the TFTP server. |
|
unit <1–8> | Specifies the unit number in a stack. |
|
usb | Specifies the script loads from the USB. |
|
username <WORD> | Specifies a username for the script. |