| Command: vlacp (Ethernet Interface Configuration) |
Configures VLACP parameters for a port.
vlacp [port <port>] enable
vlacp [port <port>] ethertype <0x8101-0x81ff | 33025-33279>
vlacp [port <port>] fast-periodic-time <400-20000>
vlacp [port <port>] funcmac-addr <H.H.H>
vlacp [port <port>] slow-periodic-time <10000-30000>
vlacp [port <port>] timeout {long | short}
vlacp [port <port>] timeout-scale <1-10>
default vlacp [port <port>]
default [port <port>] vlacp ethertype
default [port <port>] vlacp fast-periodic-time
default [port <port>] vlacp funcmac-addr
default [port <port>] vlacp slow-periodic-time
default [port <port>] vlacp timeout
default [port <port>] vlacp timeout-scale
default vlacp [port <port>] enable
no vlacp [port <port>] enable
no vlacp [port <port>]
no [port <port>] vlacp funcmac-addr
None
Ethernet Interface Configuration
| Parameter | Description |
|---|---|
|
[port <port>] | Specifies the port or list of ports. |
|
enable | Enables VLACP for this port. The default is disabled. |
|
ethertype <0x8101-0x81ff | 33025-33279> | Sets the VLACP protocol identification for this port. The default is 8103. |
|
fast-periodic-time <400-20000> | Sets the fast periodic time (in milliseconds) for this port. The default is 500. |
|
funcmac-addr <H.H.H> | Sets the multicast MAC address used for the VLACPDU. Specify a MAC address in the format H.H.H or xx:xx:xx:xx:xx:xx or xx.xx.xx.xx.xx.xx or xx-xx-xx-xx-xx-xx. |
|
slow-periodic-time <10000-30000> | Sets the slow periodic time (in milliseconds) for a specific port type. The default is 30000. |
|
timeout {long|short} | Sets the port to use the long or short timeout: long sets the port to use the timeout-scale value multiplied by the slow-periodic-time. short sets the port to use the timeout-scale value multiplied by the fast-periodic-time. For example, if you specify a short timeout, set the timeout-scale value to 3, and the fast-periodic-time to 400 ms, the timer will expire within 1000 to 1200 ms. The default is long. |
|
timeout-scale <2-10> | Sets a timeout scale for this port used to calculate the timeout. The default value is 3. |