rate

Defines the rate at which active probes should be sent.

rate <value> <unit>
 
no rate
 

• value--number portion of the rate
• unit--unit portion of the rate; must be one of:
• per-second
• per-minute
• per-hour
• per-day

Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.

Use once per active-measurement group.

3 per minute

Use the rate command while in active-measurement group configuration mode (config-engine-active) to set a group-wide rate at which probes will be contacted.

This rate will be used for all targets that are members of the group but for which an individual rate was not specified.

See the target command for information about setting individual probe rates.

See the active-measurement group command for an overview of active-measurement groups.

Use the no form of the command to remove a rate from a group.