refresh-time acquire

Sets the time to wait between attempts to find a convergence point for a target for the first time.

refresh-time acquire [ seconds ]
 
no refersh-time acquire
 

• seconds--time in seconds, in the range 0 through 31,556,736 (1 year).

Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.

Use once.

21600

Use the refresh-time acquire command to set the number of seconds to wait between each attempt to find a new convergence point. This applies only until a convergence point for a particular target has been found for the first time. After a convergence point has been found for the first time, but subsequently becomes unreachable, the time specified with the reacquire key word will apply.

Use the no form of the command to reset the value to its default.