refresh-time reacquire

Sets the time to wait between subsequent attempts to find a convergence point for a target.

refresh-time reacquire [ seconds ]
 
no refersh-time reacquire
 

• seconds--time in seconds, in the range 0 through 31,556,736 (1 year).

Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.

Use once.

1800

Use the refresh-time reacquire command to set the number of seconds to wait between each attempt to find a new convergence point. This applies after a convergence point for a particular target had been found but was subsequently lost or invalid. For targets where a convergence point has never been found, the time specified with the acquire key word will apply.

Use the no form of the command to reset the value to its default.