rsync target

Specify the remote site for rsync replication.

rsync target <host>[:<port>]::<path>
 
no rsync target
 

• host--host name or IP address of the remote machine
• port--port for access to remote rsync server
• path--directory on the remote host where replication will occur

Must be in configuration mode (config), which requires privileged-level access.

port--873

The rsync target command specifies the target of the rsync operation. Separate host and port with a colon and no space. Separate port and path with two colons and no space (the CNA software does not support rsync via SSH at this time).

Path is the rsync root on the remote system.

See the rsync enable and rsync username commands.

If you use the copy command with the rsync keyword, the CNA software will use authentication and target data set by the rsync username and rsync target commands. If these commands have not been configured, then you will have to enter this data on the command line as part of the copy command syntax.