send-data

Turns on a stream of outgoing data to a remote receiver.

send-data <type> <address> <port>
 
no send data <type> <address> <port>
 

• type--type of data stream; can be one of the following:
• decision--send CNA decision-maker process data
• http-request--send web-hit/HTTP request data
• utt--send CNA user traffic test (UTT) data
• address--IP address of receiver
• port--port on receiver; range: 1024 through 65535

Must be in configuration mode (config), which requires privileged-level access.

Available for use multiple times in the configuration.

No data streams are enabled

Use the send-data command to initiate an outgoing stream of data to a remove receiver.

If type is utt, the data stream will consist of measurement data from user traffic tests and active probes.

If type is http-request, the data stream will consist of logs of HTTP requests received from user traffic tests.

Multiple receivers can listen to each data stream.

For more information about the send-data command, contact Avaya support.

Use the no form of the command to turn off a specified data stream.