show interfaces

Displays information about interfaces.

show interfaces [ <num> <type> ] 
 
                [ detail ]
 
                [ | { include | exclude | begin } <exp> ] 
 
                [ > <url> ]
 

• num--slot or subsystem number of the USTAT module on which the interface is configured
• type--type of interface; can be:
• Ethernet
• tunnel
• loopback
• exp--a regular expression, to be used as a filter
• url--destination for output

System operations mode, login-level access.

The show interfaces command displays information about interfaces configured on CNA modules.

If the detail keyword is not specified, each interface included in the output will be listed on a single line along with its IP address and its current state.

If the detail keyword is specified, more information about each interface will be displayed.

If slot number is not specified, the management module is assumed.

If type is specified, only interfaces of that type will be included in the output; otherwise, information about all interfaces configured on the specified module will be included.

You can pipe the command through one of the following filters:

• include--shows all lines in the output which contain a match to the specified regular expression
• exclude--shows all lines in the output except those which contain a match to the specified regular expression
• begin--shows all lines in the output beginning with the first match to the specified regular expression

The vertical-line pipe character | is required when a filter is used.

You can send the output to a remote file location, by piping the display to a remote URL (leading > required). See the copy command for URL syntax.