|
|
|
Associates probes within an active-measurement group to a specified named VIP.
use named-vip <name> no use named-vip
Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.
Use once per active-measurement group.
Use the use named-vip command to associate probes with a named VIP (virtual IP address) that has previously been created on each USTAT.
When probes are launched for the current active-measurement group, they will only be sent from USTATs on which there is a VIP with the specified name. See the vip command.
If the active measurement group was configured with both the use named-vip and use link-group commands, only those USTATs which meet both conditions will be used for the probes.
There is no comparable command for globally configured probes (not in an active measurement group).
Use the no form of the command to remove the use named-vip command from the active measurement group configuration.
See also the active-measurement group command.
|
|
|