|
|
|
Enables use of the optional Endpoint Flow Collector module as a source of probe targets for an active measurement group.
efc enable no efc enable
Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.
Use once per active-measurement group.
EFC collection of targets is off
With the optional EFC module installed, the CNA can automatically create active-measurement probes from IP address received in a Netflow or SPAN data stream.
To enable this feature, use the efc enable command in the active-measurement group configuration block.
Use the no form of the command while in active-measurement group configuration mode to remove the command from the block and disable endpoint collection for the group.
For more information about EFC, see Chapter 2: Collecting Endpoint Addresses of the CNA Basic Monitoring Guide.
|
|
|