Procedure
To create a zone or subzone:
- Access Chatter Configuration command mode. To access this mode, enter the following commands:
a.
enable (Privileged mode)
b.
configure terminal (Configuration mode)
c.
module chatter (Chatter Configuration mode)
- Enter the following command:
zone <name>
where <name> is a fully qualified name of the zone or subzone that you are creating.
The name consists of a zone and multiple subzones that are separated by a period (x.y.z format). Restrictions on the name are:
- The name cannot be an integer.
- The name must start with a letter (upper or lower case) and be followed by a letter (upper or lower case), digit, dash or underscore.
- All zone and subzone names must be unique.
For more information on this command, see zone in the CNA Command Reference Guide.
