Procedure

To rename a zone or subzone:

1. Access Privileged mode. To access this mode, enter the following command: enable.
2. Enter the following command:

rename zone <orig-name> <new-name>

where

<orig-name> is the specific, existing name of the zone or subzone that you are renaming. Enter just the name, not the fully qualified name (x.y.z).

<new-name> is the new name for the zone or subzone. Enter just the name, not the fully qualified name (x.y.z). Restrictions on the name are:

• The name cannot be an integer.
• The name must start with a letter (upper or lower case) and be followed by a letter (upper or lower case), digit, dash or underscore.
• All zone and subzone names must be unique.

For more information on this command, see rename zone in the CNA Command Reference Guide.