|
Field
|
Description
|
Values
|
|
Freq 1:
|
These fields display the result of the tone
frequency analysis, which can contain one or two frequency components.
Frequency 1 is the lower frequency and Frequency 2 is the upper
frequency.
|
- If only one component
is present, the Frequency 2 field is blank.
- If no frequency is
detected, both fields are blank. This may be a result of improper
capturing of the tone. Range is 300 Hz to 3000 Hz.
|
|
Freq 2:
|
| Freq Dev |
Specifies the range of frequencies. |
Displayed in Hz. |
|
On Time:
|
Specifies the duration of the On cycles in
milliseconds.
|
Displayed in msec.
|
| On Time Dev: |
Specifies the frequency range for which the frequency is available. |
|
|
Off Time
|
Specifies the duration of the Off cycles in
milliseconds.
|
Displayed in msec.
|
| Off Time Dev: |
Specifies the frequency range for which the frequency is dropped. |
|
|
Repetition Count
|
These fields display the results of analysis
of the number of occurrences of the on time/off time cycles.
|
Integer.
|
| Disconnect Situation |
This field allows you to specify when the tone needs to be treated
as a disconnect. It is normally used in countries where disconnect
signaling is achieved through call progress tones. |
0 - Tone will not be recognized as a disconnect tone.
1 - Tone will be recognized as a disconnect tone during voice
coding only.
2 - Tone will be recognized as a disconnect tone during at all
time other than out bound calling.
|
| Reported As |
This field is displayed on the additional tone pages only. This
field takes the value of the Basic Tone type of either Dial, Busy,
Ring, or Reorder Tone, and reports the value to the system. If the
additional tone is not used, this field takes the value of "unused."
|
- Busy Tone
- Dial Tone
- Ring Tone
- Reorder Tone
- Unused
|
