The folowing table lists the CMOS parameter settings for the
MAP/5PV4.
Table: MAP/5PV4 CMOS Settings
|
Option
|
Setting
|
|
CPU Information ==>
|
|
Mother Board Type
|
KONTRON
|
|
CPU Type
|
566 Mhz-CELERON-Pentium-III
|
|
Controller Type
|
IDE
|
|
Bios Version
|
11/30/2000-i440BX-FD-2a69KD40C-00
|
| Standard CMOS Setup ==> |
| Drive C Type |
User |
| Drive C Cylinders High Byte |
Hi16383 |
| Drive C Cylinders Low Byte |
Lo16383 |
| Drive C Sectors |
63 |
| Drive C Heads |
16 |
| Drive C Mode |
Normal |
| Drive A |
1.44M, 3.5 in. |
| Drive B |
None |
| Video |
EGA/VGA |
| Halt On |
All,But Keyboard |
|
BIOS Features Setup ==>
|
|
Virus Warning
|
Disabled
|
|
CPU L1 Cache
|
Enabled
|
|
CPU L2 Cache
|
Enabled
|
|
CPU L2 Cache ECC Checking
|
Enabled
|
|
Quick Power On Self Test
|
Disabled
|
|
Boot Sequence
|
A, C, SCSI
|
|
Swap Floppy Drive
|
Disabled
|
|
Boot Up Floppy Seek
|
Disabled
|
|
Boot Up NumLock Status
|
On
|
|
Typematic Rate Setting
|
Disabled
|
|
Typematic Rate (Chars/Sec)
|
6
|
| Typematic Delay (Msec)
|
250
|
|
Security Option
|
Setup
|
|
PCI/VGA Palette Snoop
|
Disabled
|
|
OS Select For DRAM > 64MB
|
Non-OS2
|
|
HDD S.M.A.R.T. Capability
|
Disabled
|
|
Processor Serial Number
|
Disabled
|
|
Chipset Features Setup ==>
|
|
SDRAM RAS-to-CAS Delay
|
3
|
| SDRAM RAS Precharge Time |
3 |
| SDRAM CAS Latency Time |
2 |
| SDRAM Precharge Control |
Disabled |
| DRAM Data Integrity Mode |
ECC |
| System BIOS Cacheable |
Disabled |
| Video BIOS Cacheable |
Disabled |
| Video RAM Cacheable |
Disabled |
| 8 Bit I/O Recovery Time |
1 |
| 16 Bit I/O Recovery Time |
1 |
| Memory Hole At 15M-16M |
Disabled |
| PCI 2.1 Compliance |
Disabled |
| AGP Aperture Size (MB) |
64 |
| CPU/PCI Clock (MHz) |
Default |
| Spread Spectrum |
Disabled |
| Power Management Setup ==> |
| ACPI Function |
Disabled |
| Power Management |
Disabled |
| PM Control by APM |
Yes |
| Video Off Method |
DPMS |
| Video Off After |
NA |
| MODEM Use IRQ |
3 |
| Standby Mode |
Disabled |
| Suspend Mode |
Disabled
|
| HDD Power Down |
Disabled |
| VGA Active Monitor |
Disabled |
| Soft-Off by PWR-BTTN |
Instant Off |
| PWR Lost Resume State |
Last State |
| Resume on Ring |
Disabled |
| Resume on LAN |
Disabled |
| Resume on Alarm |
Disabled |
| PNP/PCI Configuration ==> |
| Resources Controlled By |
Manual |
| Reset Configuration Data |
Disabled |
| IRQ-3 Assigned to |
PCI/ISA PnP |
| IRQ-4 Assigned to |
PCI/ISA PnP |
| IRQ-5 Assigned to |
Legacy ISA |
| IRQ-7 Assigned to |
PCI/ISA PnP |
| IRQ-9 Assigned to |
PCI/ISA PnP |
| IRQ-10 Assigned to |
PCI/ISA PnP |
| IRQ-11 Assigned to |
PCI/ISA PnP |
| IRQ-12 Assigned to |
Legacy ISA |
| IRQ-14 Assigned to |
PCI/ISA PnP |
| IRQ-15 Assigned to |
PCI/ISA PnP |
| DMA-0 |
PCI/ISA PnP |
| DMA-1 |
PCI/ISA PnP |
| DMA-3 |
PCI/ISA PnP |
| DMA-5 |
PCI/ISA PnP |
| DMA-6 |
PCI/ISA PnP |
| DMA-7 |
PCI/ISA PnP |
| Assign IRQ for VGA |
Enabled |
| Assign IRQ for USB |
Disabled |
| PCI Slot 1 Use IRQ |
Auto |
| PCI Slot 2 Use IRQ |
Auto |
| Used MEM Base Address |
N/A |
| Integrated Peripherals ==> |
| IDE HDD Block Mode |
Enabled |
| IDE Primary Master PIO |
Auto |
| IDE Primary Slave PIO |
Auto |
| IDE Secondary Master PIO |
Auto |
| IDE Secondary Slave PIO |
Auto |
| IDE Primary Master UDMA |
Auto |
| IDE Primary Slave UDMA |
Auto |
| IDE Secondary Master UDMA |
Auto |
| IDE Secondary Slave UDMA |
Auto |
| On-chip Primary PCI IDE |
Enabled |
| On-chip Secondary PCI IDE |
Enabled |
| USB Keyboard Support |
Disabled |
| Init Display First |
AGP |
| Display Device Select |
CRT |
| Watchdog Timer Select |
0.5 Sec |
| KBC Input Clock |
8 MHz |
| Onboard FDC Controller |
Enabled |
| Onboard Serial Port 1 |
3F8/IRQ4 |
| Onboard Serial Port 2 |
Disabled |
| UART2 Mode Select |
Normal |
| UART2 Duplex Mode |
Half |
| IR Transmission Delay |
Enabled |
| Onboard Parallel Port |
378/IRQ7 |
| Parallel Port Mode |
ECP+EPP |
| ECP Mode Use DMA |
3 |
| EPP Mode Select |
EPP1.7 |
| Keyboard/Mouse Power On |
Disabled |
| KB Power On Password |
Enter |
| KB Power On Hot Key |
Ctrl-F1 |
