Managing the Backup Media

• About the Backup Media
• Alternating the Backup Media
• Replacing the Backup Media
• Viewing the Contents of the Backup Media
• Ejecting the Backup Media

About the Backup Media

The INTUITY AUDIX LX system uses rewritable compact disc (DVD-RW) media to back up data. In the event of a system failure, the data stored on the media is used to restore the INTUITY AUDIX LX system to an operational state.

The DVD-RW media used to back up data holds approximately 650-MB of data and supports writing speeds greater than 4x. Avaya recommends using DVD-RW media labeled as "4x–10x compatible". If a backup is attempted using a DVD-RW medium that supports writing speeds less than or equal to 4x, for example, 1x–4x or 4x, the backup will fail.

Alternating the Backup Media

To ensure that acceptable backup data is available when needed, do not use only one backup DVD-RW medium. It is recommended that you alternate between at least two DVD-RW media for unattended backups. Additional media can be used to implement a longer cycle. For example, you could alternate backups among seven backup media, each one labeled with one day of the week.

After an unattended backup is complete or an attended backup medium is full, label the backup media with the current date or day of the week, depending on your backup cycle, along with the backup data type. Then store the backup medium in a secure location. A second backup medium must then be inserted into the drive in anticipation for the next unattended backup or to complete an attended backup if the attended backup requires more than one backup medium.

Replacing the Backup Media

It is recommended that you replace the backup media every 12 months. When labeling a backup DVD-RW medium for the first time, write the replacement date on the backup medium to help identify when it needs to be replaced.


Viewing the Contents of the Backup Media

The following procedure explains how to view the contents of the backup medium.

To view the contents of the backup medium:

• Start at the Messaging Administration main menu and select Backup Attributes.

The system displays the View Attributes of Backup Media page, which contains the following information:

• The DVD-RW medium number, and the name of the machine
• The date and time of the backup
• A list of the data types that were backed up
• A list of the packages installed on the system at the time of backup

Ejecting the Backup Media

Ejecting the Backup Media by Pushing the Button on the Front of the DVD-RW Drive

To eject the backup medium from the drive:

• Press the round button on the lower right side of the DVD-RW drive.

Top of page