|
|
|
|
|
The start_vs command brings the system up to a fully operational state.
Synopsis
start_vs
Description
The start_vs command returns the voice system software to fully operational state. If you use the stop_vs command to stop the system, you should use the start_vs command to start it again. The start_vs also should be used if the system was rebooted or powered down after stop_vs was used, or if the system is not administered to automatically start the voice system when it has been rebooted.
The start_vs command checks to see if the user stopped the system with the stop_vs command. The start_vs command places all cards placed in the manual-out-of-service (MANOOS) state with the stop_vs command in the in-service (INSERV) state.
Note:
You must be logged on to the system console as root to use the start_vs command.
Example
The following example starts the voice system software:
start_vs
See also
