Changing equipment states

To change equipment states:

1. From web administration, go to the Change State of Voice Equipment screen (Configuration Management > Voice Equipment >Equipment State).

   The system displays the Change State of Voice Equipment screen. For information about this screen, see Change State of Voice Equipment screen.

2. In the New State field, do one of the following:
   • To change the state of the voice equipment to in service, select inserv.
   • To change the state of the voice equipment to manual out-of-service, select manoos.
3. In the Equipment field, do one of the following:
   • To change the state of a card, select card.
   • To change the state of a channel, select channel.
4. In the Equipment Number field, do one of the following:
   • To change the state of a single card or channel, type a single equipment number.
   • To change the state of a consecutive range of cards or channels, type a range of equipment numbers separated by a dash.
   • To change the state of a non-consecutive list of cards or channels, type a list of equipment numbers separated by commas or spaces.
   • To change the state of all cards or channels, type all.
5. In the Change Immediately? field, do one of the following:
   • To change the state of the equipment immediately, which will disconnect active calls, select YES.
   • To change the state of the equipment after current calls end, select NO.
6. Select Submit.

   The system displays information about the success or failure of the administration attempt.

© 2006 Avaya Inc. All Rights Reserved.