|
|
|
|
|
Use this screen to choose a card to assign to the Loop Start E1 digital interface.
In IR R2.0, you have the option of maintaining multiple protocols on the same NMS board. You can perform this operation by assigning multiple protocols on the same NMS board.
Field description
Field |
Description |
Card |
The number corresponding to an unassigned E1 card. Values: Shown in drop-down list box |
Trunk 1 |
If this trunk has been assigned a protocol, then it is displayed as greyed out. If you want to assign the Loop Start protocol to this trunk, select the checkbox corresponding to Trunk 1. If this trunk has been assigned a different protocol and you want to assign the Loop Start protocol to this trunk you need to unassign the card. See the Unassign Digital interface card screen for more information Values: LOOP |
Trunk 2 |
If this trunk has been assigned a protocol, then it is displayed as greyed out. If you want to assign the Loop Start protocol to this trunk, select the checkbox corresponding to Trunk 2. If this trunk has been assigned a different protocol and you want to assign the Loop Start protocol to this trunk you need to unassign the card. See the Unassign Digital interface card screen for more information Values: LOOP |
Trunk 3 |
If this trunk has been assigned a protocol, then it is displayed as greyed out. If you want to assign the Loop Start protocol to this trunk, select the checkbox corresponding to Trunk 3. If this trunk has been assigned a different protocol and you want to assign the Loop Start protocol to this trunk you need to unassign the card. See the Unassign Digital interface card screen for more information. (This trunk is only applicable for quad port cards) Values: LOOP |
Trunk 4 |
If this trunk has been assigned a protocol, then it is displayed as greyed out. If you want to assign the Loop Start protocol to this trunk, select the checkbox corresponding to Trunk 4. If this trunk has been assigned a different protocol and you want to assign the Loop Start protocol to this trunk you need to unassign the card. See the Unassign Digital interface card screen for more information. (This trunk is only applicable for quad port cards) Values: LOOP |
Button descriptions
Button |
Description |
Submit |
Displays the Assign Loop Start E1 parameters screen |
Reset |
Sets field to its default value |
Cancel |
Displays the Assign Card screen |
Help |
Displays the system help files |
Administration procedures
