Sending a test message to a remote subscriber

This topic provides information on sending a test message to a remote subscriber as part of acceptance testing.

Notes:

• For systems supporting analog remote machines, switch integration setup must be performed prior to completing this procedure.
• This test assumes that remote subscribers for each remote machine type being tested have been administered on the Message Networking system and that onsite personnel are involved in this test.

Complete the following steps to confirm that subscribers on remote machines administered on the Message Networking system can send messages via Message Networking:

1. Log in to a mailbox on a remote machine connected to the Message Networking system.
2. Create a message, such as, "This is a test message from <remote machine name>."
3. Address the message to a subscriber on another remote machine.
4. Verify the receipt of the message by the receiving subscriber.
5. Request that a message be sent from a subscriber on each type of remote machine administered on the system to another remote subscriber.

Top of page