Check your onsite equipment

Made Easy Tool for DEFINITY Media Server Configurations
Issue 4, May 2002

Add IP Solutions

Check your onsite equipment

Return to Task List

Have the following equipment on site before your shipment arrives:

An unoccupied port slot in the Avaya Media Gateway for each TN2302AP IP Media Processor

Note:

The TN2302AP consumes 16 W of power per slot compared with an average of 15 W per slot. Do not fill every available slot in a given carrier with them.

An additional unoccupied port slot for the TN799x, if needed. If you have an existing C-LAN TN799x circuit pack, replace it with the TN799DP or later if it is to be used for IP solutions registration.

A 10 BaseT or 10/100 BaseT Ethernet connection into your local area network (LAN) for the TN2302AP.

A 10 BaseT Ethernet connection into your LAN for the TN799x.

Two or more valid, unused IP addresses on your network (one for each TN2302AP or TN802/B and one for each C-LAN) that can be assigned to the IP Media Processor server. You also need the subnet mask and default gateway.

See Check your shipment to make sure you have everything you need to start the installation procedure.

Return to Task List

Send comments to MadeEasy Development Team

Always check at the Made Easy Web site for the most current information.