DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

Made Easy Tool for DEFINITY Media Server Configurations
Issue 4, May 2002



System 75 Small-Cabinet to R8si (Blowback)

Remove circuit packs (A and B carriers) [75 small upgrade]

Return to Task List

Note

This procedure is for A and B carrier systems only.


Danger! Before inserting or removing a circuit pack from a cabinet, put on a wrist strap and attach its plug or clip to the cabinet's frame.

  1. To ensure that the port circuit packs (in the A and B carriers) and the power units (in the B carrier) are properly replaced, label each component with its slot number.

  2. Disconnect the power cords from the power units in the B carrier.

  3. Remove all port circuit packs from carriers A and B and the power units from carrier B. Store the circuit packs in the static-proof packaging.

  4. Remove the circuit-pack blanks from slots that do not contain circuit packs.

  5. Remove the front trim plate from the A carrier by pulling straight off.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2002 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.