Signaling Protocol Identifier

Use the following procedure to set or change the Signaling Protocol Identifier. A valid SIG Protocol Identifier is either 0 (default), 1 (H.323), or 2 (SIP).

NOTE: Perform this procedure only if the LAN Administrator instructs you to do so.

1. When you select SIG from the Craft Local Procedure Screen, the telephone prompts you to use the Right and Left navigation arrows to select a setting and displays the following text:

where, except for the 9610 which displays the actual value, the text string is the wording associated with the current system value of NVSIG, defined as:

• "Default" when NVSIG = 0
• "H.323" when NVSIG = 1
• "SIP" when NVSIG = 2
2. To change the setting, press the Right (or Left) navigation arrow to cycle through the settings.

Depending on the current value, the next sequential text string is selected and displayed as the setting. For example, if the current value is SIP (2), pressing the Right arrow changes the value to 0 (default). If the current value is H.323 (1), pressing Right arrow changes the value to 2 (SIP).

3. Press Save to store the new setting and redisplay the Craft Local Procedure screen.

The remainder of this procedure depends on the status of the boot and application files.
For information, see Appendix A: Restart Scenarios.