Entering Data for Administrative Options

This section applies to all 9600 Series IP Telephones and describes how to enter data for administrative options.

1. The first application line on any screen is automatically highlighted (selected) when the telephone displays the screen. To select the item on that line, press the appropriate softkey at the bottom of the screen, for example, Change or Save, or the OK button. To select a different line, use the down or up navigation arrows to change the line focus. When the desired line is highlighted, then press a softkey or OK to select that line.
2. Attempts to enter invalid data are rejected and the telephone emits an error beep.
3. If you enter a numeric digit that causes the IP Address or subnet mask value to exceed 255, or any value to exceed its maximum field value, an error beep tone sounds, the digit is ignored, and the cursor does not move forward.
4. If you enter a numeric digit for a value or for an IP Address or subnet mask field after entering only a zero, the new digit replaces the zero.
5. Press the # button to go to the next step.
6. To backspace, press the leftmost softkey. When you press the applicable button or key to backspace, the most recently entered digit or period is erased from the display. The cursor remains in the erased character’s former position.
7. Pressing Exit exits the local procedures. If any changes were made using the ADDR procedure or if the Crafts Entry screen was invoked during startup, the telephone immediately resets. If no ADDR changes were made or if the local procedures were invoked post-startup, the telephone redisplays the screen (or other display) that was effective when the craft options was invoked.

NOTE: If PROCSTAT has been administered to 1, you will not be able to invoke any administrative options other than V I E W.