Enabling an Access List

You can enable an access list on the switch through the Web Agent and the CLI.

When you enable an ACL, the switch:

• May change the maximum number of forwarding entries for IP unicast traffic to improve the performance of the switch. If the maximum number of entries is set to:
• Less than 15,000, the switch automatically doubles the setting.
• Between 15,000 and 30,000, the switch changes the setting to 30,000.
• Greater than 30,000, the switch does not change the setting.
• Automatically sets hash mode for IP unicast traffic to SA-DA. This setting improves the performance of the switch when an ACL is enabled.