Configuring a Static Route for the PPP Console

Web Agent Procedure

To configure a PPP Console static route:

1. Configure your console serial port as a PPP Console. See the "Connecting a Modem" section in Chapter 2:�Setting Up the Switch.
2. In the navigation pane, expand the Routing > IP > Configuration folders, and then click Static Routes.

The IP Static Routes Web page is displayed in the content pane.

3. Select CREATE. The Add IP Static Routes Web page opens (Figure�97).
4. Enter the IP address that is to be associated with the PPP console port in the Network Address field.
5. Enter the network mask IP address in the Mask field.
6. Enter the IP address of the gateway associated with this static route in the Next-Hop Address field.
7. Click CREATE to save your changes, or CANCEL to restore previous settings. The IP Static Routes Web page reopens.
8. Click APPLY to save your changes, or CANCEL to clear your selection.