|
|
|
To remove the NBMA neighbors using the CLI, enter the following command at the (configure router:ospf)# prompt:
(configure router:ospf)# no nbma-neighbor <ip address>
Note: Do not change the type of interface after you have created it. If you need to change the interface type, delete the old one and create a new one.
Note: Poll-interval of NBMA interface decreases in value to 0, during the operation. It does not affect the operation of OSPF on an NBMA interface. A panic message will display. Ignore this message.
Note: NBMA RIP2 Poison Reverse in MD5 mode does not advertise all the routes in the Route Table.
RIP2 MD5 Authentication sequence numbers do not persist after you reset the switch.
|
|
|