Web Agent Procedure

To use the Web Agent to enable the MAC Address Lock feature and traps for unknown source addresses:

1. Manually add the "permitted" MAC addresses to the Address Forwarding Table (AFT).

For information on how to manually add MAC address to the AFT, see "Adding Static Entries to the AFT" in Chapter 9:�Managing the Address Forwarding Table.

2. Open the Switch Port Configuration Web page for the port.

For information on how to open this Web page, see "Configuring Switch Ports Settings."

3. Set the Allow Learning field to Disable.
4. Set the Known Mode field to Enable.

Note: To prevent the flooding of frames that have unknown destination addresses, set the Known Mode field to Enable for all ports on the same VLAN as the port for which you are enabling MAC address lock.

5. Set the Intrusion Trap field to Enable.
6. Adjust the trap timer, if desired.

The default setting for the intrusion trap timer is 1800 seconds (30 minutes). The valid range for the timer is 60 to 1800 seconds.

7. Click Apply.