CLI Command
Use the following CLI commands to configure syslog event reporting:
- To enable or disable syslog event reporting,
(configure)# set syslog {enable | disable}
- To configure which events are logged,
(configure)# set syslog facility {start | system | config | temp | resource | fan | service_port | user _port | power | bridge_stat | switch_fabric | ospf | rip | ldap | appletalk | auth_failure | redundant_cpu | dvmrp | cli | snmp | unknown_mac | vrrp | login_status | acl_log | ssl_ssh | all}
- To set IP addresses of remote syslog servers,
(configure)# set syslog server_ip <ip_address>
- To set a severity level,
(configure)# set syslog severity {emergency | alert | error | warning | normal | informational}
- To view the current configuration for syslog even reporting,
> show syslog config
- To view events in the syslog buffer,
> show syslog buffer
