Error Log Entries and Test to Clear Values

Previous page

Next page

Error Log Entries and Test to Clear Values

Table 51. Analog Line Error Log Entries�
Error Type	Aux Data	Associated Test	Alarm Level	On/Off Board	Test to Clear Value
0*	0	Any	Any	Any	test port GGGVSpp sh r 1
1(a)	40960 40975 40977	none
15(b)	Any	Audits and Updates Test (#36)
18	0	busy station extension	WRN	ON	release station extension
130(c)		None	WRN	ON	test port GGGVSpp sh
257(d)	40973	none
513(e)		Station Present Test (#48)	WRN	OFF	test port GGGVSpp sh r 2
769		Battery Feed Test (#35)	MIN/ WRN**	ON	test port GGGVSpp sh r 2
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the appropriate test description and follow the recommended procedures.
Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the set options** command.

Notes:

(a) Error Type 1: these are in-line errors and can only be resolved over time.

Aux Data 40960 indicates that too many simultaneous incoming ringing attempts were made on this board. Only 4 ports on a board may ring simultaneously. A 5th incoming call will cause an inline error from the board.
Aux Data 40975 indicates that the terminal equipment was on-hook when ring-tip was detected during ringing. This usually indicates a failure in the terminal equipment or the type of terminal has a low ringer impedance.

Call the terminal equipment and verify that the terminal rings.
If the terminal does not ring, then replace it.
Otherwise, issue the test port GGGVSpp command, and follow the procedure for Test #48.

40977 indicates that no terminal equipment was connected when ringing was attempted.

Run the short test via the test port GGGVSpp command, and follow the procedure for the results of Test #48.

(b) Error Type 15: this is a software audit error that does not indicate any hardware malfunction.

Run the Short Test Sequence and investigate any associated errors.

(c) Error Type 130: this error type indicates that the Media Module has been removed or has been insane for more than 11 minutes.

To clear the error, reseat or replace the Media Module.

(d) Error Type 257: this is an in-line error and can only be resolved over time. This error indicates that ringing voltage is absent.

If not resolved over time, replace the module.

(e) Error Type 513:Test #48 can cause some terminal equipment to ring briefly during daily maintenance.

If this disturbs the customer or the terminal equipment, disable it by setting the Tests field on the change station extension form to n. This may also disable Test #35.

Previous page

Next page