Error Log Entries and Test to Clear Values

Error Log Entries and Test to Clear Values

Table 9. DID-DS1 Trunk Error Log Entries
Error Type	Aux Data	Associated Test	Alarm Level	On/Off Board	Test to Clear Value
0*	0	Any	Any	Any	test trunk grp#/mbr#
1(a)	Any
15(b)	Any	Port Audit and Update Test (#36)
18(c)			WARNING	OFF	release trunk grp#/mbr#
130(d)		None	WARNING	ON	test trunk grp#/mbr#
257(e)	57474 57473
513(f)	57392		MIN/MAJ**
769(g)	57393		MIN/MAJ**
1793(h)					test board GGGVSpp
2305(i)	50944	None	MIN/MAJ**	OFF
3840(j)		Port Audit and Update Test (#36)
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the appropriate test description and follow the recommended procedures.
**This alarm will only be raised when the System-Parameter Country form has the Base Tone Generator field set to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this trunk group are out of service, then the alarm will be upgraded to a MAJOR alarm.
***Major alarms may be downgraded to Warning alarms based on the value used in the set options command.

Notes:

(a) Error Type 1--DS1 Interface Media Module detects a hardware error on the DS1 DID trunk. The Aux Data field indicates the following:

57476

On-hook before wink

57477

On-hook before ready to receive digits

57485

Wink too short for valid signal

57476	On-hook before wink
57477	On-hook before ready to receive digits
57485	Wink too short for valid signal

Maintenance does not start any testing or generate any alarms in response to these errors.

(b) Error Type 15--This is a software audit error that does not indicate any hardware malfunction. Run Short Test Sequence and investigate errors (if any).
(c) Error Type 18--The trunk has been taken out of service by a demand busyout. No calls can be made on this trunk.
(d) Error Type 130--This error type indicates that the Media Module has been removed or has been insane for more than 11 minutes. To clear the error, reinsert or replace the Media Module.
(e) Error Type 257--DS1 Interface Media Module detects a hardware error on the DS1 DID trunk. The Aux Data field indicate the source of the error:

57474

Rotary dial rate above 12 pulses per second

57473

Rotary dial rate below 8 pulses per second
(f) Error Type 513--DS1 Interface Media Module detects a hardware error on the DS1 DID trunk. Aux Data 57392 indicates no external release on PBX disconnect.
(g) Error Type 769--DS1 Interface Media Module detects a hardware error on the DS1 DID trunk. Aux Data 57393 indicates belated external release on PBX disconnect.
(h) Error Type 1793--DS1 Interface Media Module is out-of-service. Look for DS1-MM errors in Hardware Error Log. Refer to the appropriate "DS1-MM" information for details.
(i) Error Type 2305--This error indicates that a signaling change was detected by the PBX trunk Media Module which is inconsistent with the present state of the trunk.
(j) Error Type 3840--Port Audit and Update Test (#36) failed due to an internal system error. Enter status trunk command to verify the status of the trunk. If the trunk is out-of-service, then enter the release trunk command to put it back to in-service. Retry the test command.

57474	Rotary dial rate above 12 pulses per second
57473	Rotary dial rate below 8 pulses per second