Port Audit Update Test (#36)

Port Audit Update Test (#36)

This test sends updates of the CO port translation for all ports on the Media Module which have been translated. The update is non-disruptive and guards against possible corruption of translation data contained on the Media Module. No response message is expected from the Media Module once it receives translation updates. The port translation data includes: ground or loop start trunk, tone or rotary dialing trunk, rotary dialing inter-digit timing, network balance R/RC, and disconnect timing.

Table 29. TEST #36 Port Audit Update Test �
Error Code	Test Result	Description/ Recommendation
	ABORT	Could not allocate the necessary system resources to run this test. Retry the command at 1-minute intervals a maximum of 5 times.
2100	ABORT	Could not allocate the necessary system resources to run the test.
	FAIL	Internal system error. Retry the command at 1-minute intervals a maximum of 5 times.
	PASS	This test passed. Translation information was successfully updated on the Media Module. User-reported troubles on this port should be investigated by using other port tests and by examining trunk or external wiring. If the trunk is busied out, the test does not run, but returns PASS. To verify that the trunk is in-service: Enter status-command to verify that the trunk is in-service. If the trunk is in-service, no further action is necessary. If the trunk is out-of-service, continue to Step 2. Enter release-trunk command to put trunk back into in-service. Retry the test command.