MG-ANA (ANALOG MM711)

MG-ANA (ANALOG MM711)

Note:

For more information, refer to the MO XXX-BD section of this document. In addition, refer to the AN-LN-PT MO and to the CO-TRK MO.

Table 53. MG-ANA (ANALOG MM711)

MO Name (in Alarm Log)

For Location

Full Name of MO

MG-ANA

GGGVSPP

ANALOG MEDIA MODULE

Note: You must consult local records for the location and designation of the equipment rack where the G700 is mounted.

Note:	For more information, refer to the MO XXX-BD section of this document. In addition, refer to the AN-LN-PT MO and to the CO-TRK MO.

Table 53. MG-ANA (ANALOG MM711)
MO Name (in Alarm Log)	For Location	Full Name of MO
MG-ANA	GGGVSPP	ANALOG MEDIA MODULE
Note: You must consult local records for the location and designation of the equipment rack where the G700 is mounted.

The MM711 Analog Trunk and Line Media Module provides 8 ports, any of which may be administered as one of the following:

Table 54. MM711 Analog Trunk and Line Media Module - port administration�
Function	Group Type	Trunk Type	LED MWI
Central Office trunk (CO)	co fx wats	loop start ground start
CAMA/E911 trunk	cama	loop start
Direct Inward Dialing (DID) trunk	did	wink start immed start
Analog Line on-or-off premises	n/a	n/a	with/ without MWI

The MM 711 Analog Media Module supports eight analog interfaces allowing the connectivity of Loop Start, Ground Start, Analog DID trunks, and 2-wire analog Outgoing CAMA E911 trunks. As well, the MM711 Analog Media Module allows connectivity of analog, tip/ring devices such as single line telephones, modems, or group 3 fax machines. Each port may be configured as either a trunk interface or a station interface.

Also included is support for caller ID signaling, ring voltage generation for a variety of international frequencies and cadences and administrable line termination styles.

The MM711 Analog Trunk and Line Media Module does not support Neon Lamp Message Waiting Indication (MWI). No maintenance of the terminal connected to the Neon Analog Line Media Module is performed.