|
|
|
Admonishments used in the documentation for this product have the following meanings:
CAUTION: Indicates the presence of a hazard that will or can cause minor personal injury or property damage if the hazard is not avoided.
WARNING: Indicates the presence of a hazard that can cause death or severe personal injury if the hazard is not avoided.
DANGER: Indicates the presence of a hazard which will cause death or severe personal injury if the hazard is not avoided.
SECURITY ALERT: This sign is used to draw attention to possible toll-fraud issues.
The G700 Media Gateway uses an auto-ranging 100-240 VAC power supply, 50 to 60 Hz, 5 A maximum at 100-120 VAC and 2 A maximum at 200-240 VAC. The AC power source is to be single phase, 3-conductor (Line, Neutral and Ground) with a 15 A circuit breaker for 100-120 VAC or a 10 A circuit breaker for 200-240 VAC.
WARNING: Do not overload the power circuit.
WARNING: To prevent access to electrical hazards by unauthorized personnel and to ensure continued compliance to international radiated emissions requirements, all captive screws must be securely tightened such that they cannot be loosened without the use of a tool.
WARNING: The AvayaG700 Media Gateway must not be operated with any slots open. Empty slots should be covered with the supplied blank plates.
CAUTION: System grounding must comply with the general rules for grounding provided in Article 250 of the National Electrical Code (NEC), National Fire Protection Agency (NFPA) 70, or the applicable electrical code in the country of installation.
WARNING: If the installation location is greater than 50 feet (15 m) from an approved ground, do not install the AvayaG700 Media Gateway until a licensed electrician is present to install a Supplementary Ground Conductor.
WARNING: Failure to install both grounds will void the Product Safety certifications (UL and the CE Mark) on the product and create a hazard that could result in death or severe personal injury.
The equipment described in the documentation for this product may contain Class 1 LASER Device(s). The LASER devices operate within the following parameters:
CLASS 1 LASER PRODUCT EN 60825-1:1994 + A11, EN60825-2:194, EN60950:1992 + A1 + A2 + A3.
Laser components used in the G700 Media Gateway are Class 1 Laser Products that comply with 21CFR 1040.10 and CFR 1040.11.
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Contact your Avaya representative for more laser product information.
WARNING: If the rack is not securely fixed in place, do not proceed with the installation.
WARNING: Balancing the G700 Media Gateway requires two people. Use caution to avoid injury.
WARNING: If the G700 Media Gateway is being mounted in a rack with other equipment already installed, the G700 Media Gateway must be positioned to avoid imbalance.
WARNING: Installation in a Restricted Access Location is required in Finland and Norway.
|
|
|