Cabling 4 Media Gateways

1. Remove the bottom panel and fan assembly from media gateway D.
2. If not already removed, remove the fan assembly from media gateway C.
3. Remove the right TDM/LAN bus terminator from media gateway C, and install it at the left end of the TDM/LAN bus in media gateway D.
4. Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable routing slot of media gateway D and the top right TDM/LAN cable routing slot of media gateway C. See TDM/LAN bus cable routing slot plate removal.
5. Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both media gateways. Push the free end of the EMI Gasket back in place. See TDM/LAN bus cable routed through the media gateway.
6. Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus in media gateway C. Make sure the arrows on the back of the cable terminators point upward.
7. Install the upper terminator of the TDM/LAN bus cable on the right end of the TDM/LAN bus in media gateway D.
8. Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the routing slots are covered.
9. Reinstall the fan assemblies and bottom panel on each media gateway.