Enable alarms to INADS via SNMP

NOTE: Do these steps only if a Secure Service Gateway (SSG) is being installed. For further information on the SSG device see (Avaya personnel only): http://135.8.11.4/team-sra/

The following administration is done on a computer used to access the active Avaya S8700 Media Server using an MS-DOS command line interface.

1. Click Start > Run to open the Run dialog box
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as craft.
4. At the prompt type almsnmpconf -d ipaddress -c community name and press Enter. Where ipaddress is the trap receiver address for the SSG device and community name is the community string name required by the SSG device.
5. Type almsnmpconf and press Enter. Verify that the correct information was entered.
6. At the prompt type almenable -s y and press Enter.
7. Type almenable and press Enter. Verify that the SNMP alarm origination is enabled. If used, verify that alarm origination via modem is still enabled.