Media Gateway - Administration CLI Set

Media Gateway - Administration CLI Set

Administration Commands

The following commands are used for general administration on the G700 Media Gateway Processor. The commands are listed alphabetically for ease of reference:


clear screen		Clears the screen and homes the cursor
clear sync interface		Disassociates an interface as a sync source
configure		Permits the use of set commands
dir		Shows list of downloadable files
exit		Exit the session or current mode
hostname		Places 'hostname'in the command prompt
help		Shows mode-specific command help
nvram initialize		Clear NVRAM and reload factory defaults
reset		Resets a specified system resource
retstatus		Shows pass/fail status of last command
sat		Sets up session with the SAT
set hostname		Places 'hostname' in the command prompt
set logout		Sets idle time for auto-logout
set sync interface		A mode that permits change to the sync configuration
set sync source		Specifies the stratum clock source
set system contact		Sets the site contact name
set system location		Sets the name of the site location
set system name		Sets the system name
show hostname		Shows the current prompt string
show mg list_config		Shows installed MG equipment
show mm		Shows MG Media Module info
show post		Shows Power On Self Test results
show sync timing		Shows state of clocking sources
show system		Shows system ID information
show timeout		Shows the auto-logout time
tech		Changes to a mode for access to tech level commands
terminal length		Sets the number of terminal lines
terminal width		Sets or displays the number of characters per line
tree		Shows available commands