Port Audit and Update Test (#36)

Port Audit and Update Test (#36)

This test sends port level translation data from switch processor to the MG-DS1 Interface Media Module to ensure that the wideband access endpoint port's translation is correct.

Table 178. TEST #36 Audit and Update Test
Error Code	Test Result	Description/ Recommendation
	ABORT	Internal system error Retry the command at 1-minute intervals a maximum of 5 times.
1006	ABORT	The port is out-of-service. If the port is busied out: Issue release access-endpoint <extension> command to put the port back into in-service. Retry the test command. If the port is not busied out: Check the error and alarm logs for WAE-PORT and MM-DS1 errors and alarms and follow the recommended repair procedures.
2000	ABORT	Response to the test request was not received within the allowable time period. Retry the command at 1-minute intervals a maximum of 5 times.
2100	ABORT	Could not allocate the necessary system resources to run this test. Retry the command at 1-minute intervals a maximum of 5 times.
	FAIL	Internal system error Retry the command at 1-minute intervals a maximum of 5 times.
	PASS	Port translation has been updated successfully.
Any	NO BOARD	The test could not relate the internal ID to the port (no board). This could be due to incorrect translations, no board is inserted, an incorrect board is inserted, or an insane board is inserted. Ensure that the board translations are correct. Execute the add ds1 GGGVS command to administer the MG-DS1 interface if it is not already administered. If the board was already administered correctly, check the error log to determine whether the board is hyperactive. If this is the case, the board is shut down. Reseating the board will re-initialize the board. If the board was found to be correctly inserted in step 1, then issue the busyout board command. Issue the reset board command. Issue the release busy board command. Issue the test board long command. This should re-establish the linkage between the internal ID and the port.