Log in to the Layer 2 Switching Processor with
a Direct Connection to the Services Port

Use this procedure to log in to the Layer 2 Switching Processor when you have a direct connection with your laptop to the S8300 Services port.

To log in to the Layer 2 Switching Processor via the Services port

Begin _____________________

Note: If you are upgrading an S8300/G700 remotely, connect to the customer LAN and telnet to the IP address of the Layer 2 stack master (that is, the P330 stack processor running as the stack master). The IP address is the address assigned on the customer LAN, not 192.11.13.6.

1. With a direct connection to the S8300 services port, telnet to the S8300 IP address:

Type telnet 192.11.13.6.

2. Login as craft or cust.
3. Telnet to the Layer 2 stack master processor.

Type telnet <xxx.xxx.xxx.xxx>, where <xxx.xxx.xxx.xxx> is the IP address of the Layer 2 stack master processor on the customer's LAN.

4. Login at the Welcome to Avaya P330 screen.

Login: xxx from the planning documentation
Password: xxx from the planning documentation

You are now logged-in at the Supervisor level. The prompt appears as P330-1(super)#.

End _______________________

Note: To check the syntax of a command in the command line interface, type as much of the command as you know followed by help. For example:

P330-1(super)#> set help

you will be given the current list of set commands available. If you type:

P330-1(super)#> set interface help

you will be given a much more restricted list of command possibilities that address the possible interfaces to be set.

For a complete list of command line interface commands, type help or refer to the "Avaya P330 User's Guide" (available at http://www.avaya.com/support).