Avaya Support Forums

Avaya Support Forums (http://support.avaya.com/forums/index.php)
-   Enterprise PBX Communications Systems (http://support.avaya.com/forums/forumdisplay.php?f=7)
-   -   Connecting to 711 without using the FAC "9" (http://support.avaya.com/forums/showthread.php?t=13005)

marzahn 09-28-2017 11:55 AM

Connecting to 711 without using the FAC "9"
 
My firm is working into the 21st century by "fits and starts.":o One of my recent tasks is to insure that a staff person can call the 711 service when required.

I confirmed that staff can dial and connect to 711 from an internal system phone by keying “9711.” However I have not yet found the key to using only 711. my call tracing always reports a "denial event 1643: Off-hook dialing time out." What did I miss? :confused:

Though set up properly in the ARS analysis table keying "711" does not work. Also adding either of the following lines to the ARS digit conversion table...
711 3 3 3 918007455555 ars n n
or
711 3 3 3 9711 ars n n

did not work. I have tried several permutations of this both with and without the following line . . .
711 3 3 p1 svcl n
in the ARS analysis table. Next, I might try an
ars digit conversion table entry changing 711 to a VDN and having the vector route to 800-745-5555.

Anybody who has the key, please let me know.

mitta3 09-28-2017 01:50 PM

Try to dial 711 from Trunk Line TAC number and confirm if this is successful or not. then

Ensure You have a entry in dial plan for 711 3 3 as ars, put trace in CM share the trace log
also check call type should be emergency/public

Number min max route pattern type
711 3 3 9 emer

marzahn 09-29-2017 05:56 AM

That was the answer Mitta!
 
Try to dial 711 from Trunk Line TAC number and confirm if this is successful or not.
:)Success

Ensure You have a entry in dial plan for 711 3 3 as ars, put trace in CM share the trace log. Also check call type should be emergency/public
:) There is no selection "emergency/public" in my system. However dial plan entry: "711 3 3 ars" worked.

Number min max route pattern type
711 3 3 9 emer
:)using the command: "change ars analysis 7," I added the line " 711 3 3 1 emer" as we use Route Pattern 1 for local calls.

:)GOOD JOB!:)


All times are GMT -7. The time now is 11:38 AM.