Avaya Support Forums

Avaya Support Forums (http://support.avaya.com/forums/index.php)
-   IP Telephony and Convergence (http://support.avaya.com/forums/forumdisplay.php?f=8)
-   -   Outgoing ANI question (http://support.avaya.com/forums/showthread.php?t=190)

jleewms 06-10-2010 01:31 PM

Outgoing ANI question
 
I have a couple of CM systems which were upgraded from older systems. Both have the outgoing long distance going out over a 24 channel T1 set up as "Tie" type. The facilities' leaders would like to have the phone number show on outgoing calls. Is it possible?

maryb 06-11-2010 12:26 PM

I don't believe CM can control the outbound ANI unless the circuits are PRI's. We had "plain" T-1's and I was not able to setup the public-unknown-numbering table in CM which allows individuals' numbers to display on outbound calls. Once we switched over to PRI's, I am able to set that table up.Your carrier for the long distance circuits should be able to setup a single phone number for all outgoing calls but without PRI's, I think that's all you will be able to get.

ssehgal 06-22-2010 10:37 PM

Calling Party Number for Non- ISDN digital trunks
 
Yes, Calling party number can be sent over Non- ISDN digital trunks.

You need ask your provider for R2MFC CAS trunks. Not sure if these kind of trunks are being used in North America or not.


rgrds....suneet


All times are GMT -7. The time now is 08:25 PM.