Thread: 96XX VPN Mode
View Single Post
  #18  
Old 04-05-2013, 11:38 AM
macosx2new macosx2new is offline
Member
 
Join Date: May 2012
Posts: 8
macosx2new has 10 reputation points
Question NVVPNUSER in 46xxsetting file

Hi Folks, Hope all is well.

My environment:
CM 6.0.1
IP phone 9611G ver: 6.23.12
H323
Cisco ASA 55XX.

I got most of VPN configuration fingured out. But one question remaining, regarding NVVPNUSER that contains the string $MACADDR. For the life of me, I could not make the string will be replaced by the telephone's MAC address.

Any though of using IF statement to archive the goal? to stage the phone and it may be preconfigured in a file to eliminate the need for the user to manually enter the value.
## NVVPNUSER specifies the user name to use for VPN authentication.
## Normally, this value is entered by the user and not set in this file.
## However, if the user names are set in a staging environment using IF statements
## based on the telephones' MAC addresses, or if the user name is a fixed string
## based on the serial number and/or the MAC address of the telephone,
## it may be preconfigured in a file to eliminate the need for the user to manually enter the value.
Much appreciated to shed some light.

Kevin

Last edited by macosx2new; 04-05-2013 at 11:53 AM.
Reply With Quote