View Single Post
  #1  
Old 04-10-2013, 04:01 AM
gibso13 gibso13 is offline
Member
 
Join Date: Apr 2013
Posts: 6
gibso13 has 10 reputation points
Default Overflow: Detecting a busy tone

Historically i had a set up with a third party where we would put a step in to the vector to play a busy tone when we had zero availability and the thrid party was able to detect this and not send any calls.

This way we were able to act as an efficient overflow site and prevent a tap on/ tap off scenario and control the queue at a single location.

I now have a situation where this would be desirable again, but i know how to configure the vector at our end to play the busy tone, but i do not know how the third part detected the busy tone and ultimately only fed calls when a busy tone was not present.

Does anyone have any ideas on how this could be acheived?

If not, is there any other way of acheiving a similar result to prevent queueing at both sites. The two ACD's are completely spearate, our version is v6.2.

Any help/direction appreciated, unfortunately the original thrid party is not contactable for advise.

Barry
Reply With Quote