View Single Post
Old 02-07-2017, 04:41 PM
rogerg's Avatar
rogerg rogerg is offline
Join Date: Jan 2010
Location: Houston, Tx
Posts: 51
rogerg has 10 reputation points
Default CM 7 install Dumb Question

I have installed the CM 7.0 simplex VM on our LAB ESXi host. Everything is good, however when I login to ASA to setup basic translations, I am not able to see / access a change command.

I know in 6.x and earlier, I could install, but before I could add anything, I had to change system parameters maintenance, make any change, save trans then reset sys 4. ...then all would be available for 30 days...for testing (no licenses).

How do I do this in CM 7?
Gary Rogerson
Reply With Quote