View Single Post
Old 09-14-2016, 05:23 AM
ander548 ander548 is offline
Join Date: Jun 2016
Posts: 37
ander548 has 10 reputation points

Ok, I created a very simple workflow with only a Start going straight to a Terminate. On the terminate, I set the following for the input schema, and in Input Mapping I hardcoded a value of "My Output" into the Output1 value:


And when I just run this simple WF in debugger, and step through it, after the terminate executes the Debugger Console shows "Output Data" as blank. So, first of all, is that correct? Shouldn't it show my Output1 value as an Output?

But, that aside, if I deploy this WF as "Test" and then open a new workflow, when I use Create Process and point it to my "Test", it doesn't automatically populate anything for input/output schema. If I paste the schema from above into the output schema for Create Process, and map it to some variable, it still comes back blank.

So, am I doing something wrong or just missing something? Is there some way to debug the Test WF to make sure it's outputting what it should be? As best I can tell it's not outputting anything.

Reply With Quote