View Single Post
Old 11-09-2011, 06:30 AM
telferkj telferkj is offline
Join Date: Oct 2010
Posts: 3
telferkj has 10 reputation points
Default TN793CP Firmware

Using the TN793CP Analog board with FW11 [to prevent the board from going into No Board]. However during a recent upgrade to the CM software several TN793CP went into the no board state. Reset system 4 was performed which brought some boards back but caused a different group of these boards to go into the no board state. The only way to rectify the issue was to reseat all the affected boards. Has anyone experienced this issue and is there any updated Firmware releases planned. What logs may help to identify the failure
Reply With Quote