View Single Post
  #3  
Old 08-11-2017, 05:24 AM
grube11 grube11 is offline
Member
 
Join Date: Dec 2016
Posts: 6
grube11 has 10 reputation points
Default

Tested perfectly. I did notice that the Dial Delay Time count starts on the entry of the first digit, therefore any pause(s) after the first digit entered allowed the system start looking for short codes or extensions. If I entered "7" then waited more than four seconds; next entered the remaining two digits "2 and 5", the system would immediately direct the call to the extension. I will use "Enbloc Dial" to work around slower users.

I also noticed when I entered more than 3 and less than 7 total digits, I would not get the error tone. It would just wait for me to drop the call.

Thanks!!!
Reply With Quote