Thank you thiel2, this is giving me a good insight on how things work now.
I've been very careful to not add just a 0N in the expansion system. I did it with the matched ID in the ARS table. After I did the first steps you asked me to do on the first posts I learned that It the call goes from User > User Rights > down to the 500V2 > Short Codes > ARS entry ID (if there is a match).
It looks like I am able to dial internationally now when I put my extension in the INTL User Group. I added the Si"Mainnumber", just like in the other shortcodes in the 500v2 short code tab, because it seems like that is what gets sent for the caller ID.
I will post a status update later when I get a hold of a user I can use for a test call.
Again, thank you very much....there's been a lot of progress.
|