View Single Post
  #2  
Old 04-14-2012, 01:32 PM
mneumann mneumann is offline
Hot Shot
 
Join Date: Aug 2010
Posts: 16
mneumann has 10 reputation points
Arrow

Hi, pls make sure that all units of your stack have the same FW/SW.
The first Unit should be manually set to Base-Unit on the backside-switch, near the cascade cables.
All other units has to be set to NonBase.
Power on all units - your new stack will be formed successfully by "himself"

On CLI you can perform for verification those commands:

ACLI:
show stack-info
The LEDs on each unit will show you the unit-number.
Reply With Quote