View Single Post
Old 08-12-2010, 01:31 AM
pttrung pttrung is offline
Aspiring Member
Join Date: Aug 2010
Posts: 1
pttrung has 10 reputation points
Exclamation error boot image for SR2330

Dear all!

I have Nortel SR2330 and I had format the flash cf0 using the command, now I canít open my router these is the error:

Press any key to stop auto-boot...

Compact Flash Device: CF0, Filename: /cf0//SR2330.Z

Cannot open "/cf0//SR2330.Z".

Error loading package: errno = 0x380003.

Can't load boot file!!

I had use boot from ftp but can't:

Can you explain about command line as:
[00] Boot dev : ftp
[01] Boot Ethernet Port : 1
[02] Boot file name : SR2330.Z
[03] Server name : host
[04] Server IP address :
[05] My IP address :
[06] My subnet mask :
[07] Gateway IP address :
[08] User name : demo
[09] Password : wind
[10] Checksum enable [0isable,1:Enable]: 1
[11] Show header enable [0isable,1:Enable]: 0
[12] Save bootrom image [0:AutoUpdate,1:NormalBTupd,2:GoldenBTupd,3:NoUpd]: 1
[13] display mode [0:minimum,1:maximum]: 0

I canít boot from ftp server. I had setup network card my PC: and from my PC, I can ping to port Ethernet 0/1 with IPís SR2330:

C:\Users\Thanh Trung>ping
Pinging with 32 bytes of data:
Reply from bytes=32 time<1ms TTL=64
Reply from bytes=32 time<1ms TTL=64
Reply from bytes=32 time<1ms TTL=64
Reply from bytes=32 time<1ms TTL=64

Ping statistics for
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms

but error:

Copyright (c) 2009 Nortel

VxWorks : VxWorks5.5.1
BSP version : 1.1/0
Boot version : (NORMAL Boot)
Creation date : Aug 18 2009, 17:47:46
NORMAL Bt ver :
GOLDEN Bt ver :
Baseline ver : (Internal version for checking)
System name : SR 2330

Press any key to stop auto-boot...
MAC 98:d8:8c:fb:02:01
Attached IPv4 interface to mottsec unit 1

Error loading file: errno = 0x3c.
Check your network configuration
Can't load boot file!!
Reply With Quote